Allen-Bradley A-B QUALITY DL20 Series User Manual page 46

Chapter 4
Creating and Editing Messages
4–20
We will set this message up so that the display is cleared when the message is
finished. Type [Y].
Now press [Return].
We do not want the message to continually repeat so just press [Return].
We do not want to chain this message, so just press [Return].
We do not want the message to flash, so just press [Return].
We do not want to energize the relay so just press [Return]
We do not want to stack the message in the Historical Event Stack so press
[Return].
We want this message to actually be displayed, so press [Return]. The
following prompt then appears:
The last prompt appears for a few seconds indicating that a new message is
being created, followed by a cursor. The cursor is a blinking solid block; it is
shown as an underline in this manual. Enter a sample message.
Here, the string ALLEN-BRADLEY was typed in. Note that the characters
scrolled off to the left, and the cursor is positioned at the last character
typed. Type some more:
ALLEN-BRADLEY BULLETIN 2706 MESSAGE DISPLAYS
AUTO CLEAR? Y
AUTO REPEAT? N
CHAIN MSG? N
FLASH MSG? N
TURN RELAY ON? N
STACK MSG? N
INVISIBLE MSG? N
ENTER MSG
--
ALLEN-BRADLEY