Chapter Objectives
Entering the Run Mode
Autorun Feature
Run Mode
This chapter describes how to trigger and display previously entered
messages.
To place the DL20 in the run mode, answer Yes to the run mode prompt:
The DL20 clears the display and enters the run mode.
The DL20 remains in the run mode indefinitely. If power fails, the DL20
remembers that it was in the run mode. On powerup, it resumes the run
mode, if it passes the powerup self diagnostics.
The messages:
TEMP MASTER ADD:
or
and
are displayed for three seconds before the DL20 enters the run mode. If an
autorun message has been selected, it is now displayed. It takes about twenty
seconds to run the powerup self test and during this time prior to
AUTORUN, no messages may be triggered.
Chapter
5
A–B
RUN? Y
(0)
MASTER ADDRESS:
AUTORUN
5–1