Accessories - Allen-Bradley A-B QUALITY DL20 Series User Manual

Chapter 2
Introduction to the DL20

Accessories

2–6
Table 2.A lists the optional accessories.
Table 2.A
Accessories
Item
Connects Allen-Bradley Industrial Terminals T1 through
DL20 Cable T4 or most DTE type dumb terminals.
(Male 25 pin D-shell)
Connects Allen-Bradley Terminals 1784-T45, -T47, -T50,
-T60, other IBM compatibles or DEC VT52, VT100, or
VT101 Terminals. (Female 25-pin D-shell)
DL20 Cable
Use 25 to 9-Pin AT Adapter with this cable for 1784-T50
or -T60 Industrial or IBM AT computers.
Data Recorder
Connects EPI STR-LINK II or III Data Recorders to DL20.
Cable
Data Recorder Connects Allen-Bradley 1770-SB or -SA Data Recorders
Cable to DL20.
Connects A-B Terminals to EPI STR-LINK II or III Data
Recorders. Cable is required if an Allen-Bradley
A-B Terminal
Industrial Terminal and EPI STR-LINK II or III Data
Cable
Recorder is used. Cable is not needed if programming
keyboards (Catalog No. 2706-NK1 or -NK2) are used.
DL20
Off-line Programming Software for IBM or compatible
Development
computers with 5.25 inch or 3.5 inch disk drive.
Software
Keyboard Full travel keyboard
Keyboard Membrane keyboard
Allows DIP switch selection of an address when multiple
Addressing Bar DL20s are on an RS-422 network. If Addressing Bar is
not used, address is selected during programming.
Connects to the DL20 parallel input port and allows
messages to be triggered using 120 VAC inputs.
120V Parallel
Input Converter
NEMA Type 12/13 enclosure with mounting holes and
cutout for DL20. Access door has gasket.
Enclosure
Eliminates the standard bezel supplied with the display.
Flush
Mounting Kits
Description
Display Mounted Converter
Panel Mounted Converter
One or Two Line Displays
Four Line Displays
One or Two Line Displays
Four Line Displays
Catalog No.
2706-NC1
2706-NC2
2706-NC3
2706-NC4
2706-NC5
2706-NP3
2706-NK1
2706-NK2
2706-NF1
2706-NG1
2706-NG2
2706-NE1
2706-NE2
2706-NJ1
2706-NJ2