Allen-Bradley A-B QUALITY DL20 Series User Manual page 137

DL20 Configuration
Make sure that the DL20 is set for:
Baud Rate =
Parity =
Connecting EPI STR-LINK Recorders
Figure B.5 illustrates the connections. Connect the STR-LINK Recorder
(DATA SET INTERFACE connector) to the DL20 RS-232 port using the
Tape Loader Cable (Catalog No. 2706-NC3) as shown.
If you are using a keyboard (Catalog No. 2706-NK1 or -NK2), plug the
keyboard into the rear of the DL20. No other connections are required.
If you are using an Allen-Bradley Industrial Terminal (T1 through T4), use
cable (Catalog No. 2706-NC5). This cable connects to the DATA
TERMINAL INTERFACE connector on the data recorder and Port B on the
industrial terminal.
If you are using another type of dumb terminal, you must construct your own
cable.
Figure B.5
EPI STR-LINK Data Recorder
DUMB TERMINAL
MAIN
Operating Procedures
The DL20 prompts you through the procedure. If necessary, refer to the
previous Allen-Bradley Data Recorder procedures for examples.
Appendix B
Tape Recorder Setup
1200
None
EPI STR-LINK RECORDER
User Supplied Cable
2706-NC3
Tape Loader Cable
DL20 DISPLAY
6 7 8
RS RS GND
232 232
OUT IN
B–11