Connec�ng the batery charger
INFORMATION: Before charging, ensure that the charger is properly set for your batery type, otherwise damage
may occur.
Please check the batery label to ensure that the batery type is set correctly.
In order to avoid permanent damage to the bateries, it is important to avoid deep discharge. Check the charging
process. If the flashing light "discharged bateries" lights up within a few minutes, contact your service centre.
WARNING: Never allow the bateries to become completely discharged, even when the machine is not in
use, and ensure that the charger is suitable for the installed bateries in terms of capacity and type.
Aten�on! When using the on-board charger, connect the charger plug to the power supply. The charger is
working when the LED light is on.
WARNING: Leave the dirty water tank open during charging to allow vapors to escape.
7
MACHINE CLEANING
Water and detergent flow from the fresh water tank through a valve onto the floor. The brushes use the detergent
and water to scrub the floor. As the machine moves forward, the suc�on nozzle sucks the dirt solu�on from the
floor into the dirty water tank.
8
INFORMATION ABOUT BRUSHES AND PADS
For best cleaning results, use the appropriate brush type for your cleaning applica�on. For part numbers, refer to
the Parts Manual.
The following brushes and driving discs are recommended.
Scrubbing brush (53 cm) item number 566.059
Recommended for cleaning coated floors without removing the varnish.
Driving disc (53 cm) item number 566.070
To accommodate the pad.
9
MACHINE PREPARATION
Fresh water tank
The dirty water tank must be completely emp�ed each �me the fresh water tank is
filled. Remove the filler cap (1) on the right side of the machine and check that the
filter is inserted correctly.
WARNING: The dirty water tank must be completely emp�ed each �me the
fresh water tank is filled. Make sure that the filter lid (2), which is located under the fresh water tank at the
front right of the machine, is properly closed.
www.cleanfix.com
10
Need help?
Do you have a question about the RA565 IBCIBD and is the answer not in the manual?