Cleanfix RA565 IBCIBD Operating Instructions Manual page 11

Filling the fresh water tank
The fresh water tank can be filled in two different ways:
Remove the filler cap (1) and fill the tank using the rubber hose located on the le�
side of the machine. Remove the filler cap (1) and fill with clean water at a
temperature of max. 50°C. The quan�ty in the tank can be read from the level
indicator on the right front of the seat. The fresh water tank has a maximum capacity
of 65 liters. Add detergent to the tank in the concentra�on indicated on the
detergent manufacturer's label. Use only as much detergent as necessary to avoid
excessive foam which can damage the suc�on motor.
WARNING: Only use detergents whose suitability for scrubbing machines is indicated on the
manufacturer's label. Do not use acidic or alkaline products or solvents without this indica�on. Acidic or
alkaline detergents can be used if they have a pH between four and ten and do not contain oxidizing agents,
chlorine or bromine, formaldehyde, or mineral solvents.
WARNING: Always wear protec�ve gloves before handling detergents or acid or alkaline solu�ons to avoid
serious injury to hands.
WARNING: Always use low-foaming detergents. To avoid foaming, add a minimum amount of defoamer fluid to
the dirty water tank before star�ng cleaning. Do not use pure acids.
Regula�on of the detergent
Open the ball valve completely with the lever (1) on the steering column. Check
the first few meters, to see if the amount of solu�on is sufficient to wet the
ground. The amount can be adjusted with the lever (1) by pushing it down to
increase the flow or up to decrease it. Note that the correct amount of solu�on
always depends on the condi�on of the ground, the degree of contamina�on and
the driving speed.
Dirty water tank
Make sure that the dirty water tank is empty, otherwise empty it completely.
Check that the lid of the drain hose (1) (on the back of the machine) is properly
closed.
www.cleanfix.com 11