Table of Contents
Advertisement
G1066Z
Refer to Figures 4–6 and the following descrip-
tions to become familiar with the basic con-
trols and components of the Model G1066Z.
Understanding these items and how they work will
help you understand the rest of the manual and
stay safe when operating this machine.
A
B
B
A
E
Figure 4. G1066Z control panel.
A. Sanding Motor ON/OFF Buttons: Push to
start/stop sanding motor.
B. Conveyor Motor ON/OFF Buttons: Push to
start/stop conveyor motor.
C. Conveyor Speed Control: Turn to set con-
veyor belt speed between 0–10 (0–60 RPM).
D. Load Meter: Displays total amp draw of
sanding motor.
E. Emergency Stop Button: Stops motors
when pressed and disables ON buttons.
Remains in depressed position until manually
reset. Reset by twisting button clockwise until
it springs outward.
F
G
Figure 5. G1066Z front controls.
Model G1066R/Z/G1079R (Mfd. Since 02/24)
C
D
H
Conveyor Height Crank Handle: Rotate to
F.
raise or lower conveyor table according to
workpiece thickness.
G. Depth-of-Cut Scale: Indicates distance
between conveyor table and sanding drums.
H. Conveyor Table w/Belt (Infeed End):
Height-adjustable table with conveyor belt
that feeds workpieces toward sanding drums.
I
Figure 6. G1066Z sanding drums.
I.
Micro-Adjustment Lock Lever (1 of 2):
Tighten to lock micro-adjustment knob in
place.
Micro-Adjustment Knob (1 of 2): Rotate
J.
to make fine height adjustments of outfeed
(rear) sanding drum.
K. Rear Sanding Drum: Cylindrical drum with
machined surface that is covered in hook-
and-loop material. Typically wrapped with
fine grit sandpaper to perform finish sanding
portion of operation.
Front Sanding Drum: Cylindrical drum with
L.
machined surface that is covered in hook-
and-loop material. Typically wrapped with
coarse grit sandpaper to perform thickness
sanding portion of operation.
K
L
J
-7-
Advertisement
Table of Contents
