Unclog The Dry Ice Chute - Cold Jet i3 MICROCLEAN Operator's Manual

Hide thumbs Also See for i3 MICROCLEAN:

Table of Contents

Problem

Dry ice clogging the feeder chute

Unclog the Dry Ice Chute

Always wear proper personal protective equipment including eye protection to guard against flying

objects, ear protection to prevent hearing loss and gloves to protect hands from exposure to cryogenic

temperatures and sharp blade surfaces.

1. Remove the dry ice from the trough.

2. Set the feed rate control to maximum and move the applicator mode select switch to the air + ice

position (II).

3. Close the trough door and press the green power on/reset button. Hold this button down until the

green light turns on.

4. Open the chute access port.

5. Blow out the dry ice with the applicator nozzle until clear.

NOTE: Dry ice will blow out. Protect your eyes, face, and skin from contact with dry ice particles.

Click to go to Top of Document

Possible Reason

compensate for the extended length of

your blast hose setup.

Follow the

Unclog the Dry Ice Chute

procedure.

Solution

2023-12-13

Table of Contents

Do you have a question about the i3 MICROCLEAN and is the answer not in the manual?