NEC UNIVERGE SV9100 System Maintenance Manual page 3

Preface
Before Reading this Manual
This manual provides detailed information for diagnostic and maintenance information for the SV9100
system.
There are eight parts to this manual:
Chapter 1 – Troubleshooting IP on an SV9100 System
This chapter provides some helpful tips for troubleshooting IP on the SV9100 system.
Chapter 2 – System Maintenance
The technician can use this chapter to troubleshoot and diagnose problems during and after SV9100 system
installation. The troubleshooting flow charts and general test procedures help the technician identify
possible causes of the problem by defining the problem area.
Chapter 3 – Diagnostics
This chapter provides a description of the SV9100 Diagnostic Interface Module (DIM) built into the GCD-
CP10 blade. The DIM can monitor the activity of the system under the control of commands entered by the
engineer.
Chapter 4 – SV9100 Automatic Log File Export from the GCD-CP10
The SV9100 adds new options to generate and save Diagnostic files to the built-in memory card. These files
can be exported/viewed in several ways.
Chapter 5 – Alarm Reports
System alarms are reported by the system and can be viewed by WebPro, PCPro or exported as text files or
e-mail.
Chapter 6 – ISDN Layer 1 Status Display
View the connection status of the ISDN basic rate circuits, can be viewed via WebPro, PCPro or KeyTel Pro.
Chapter 7 – Keyphone Access to System Settings
Use any terminal to view the system's IP addresses, Main Software version etc.
Chapter 8 – Terminal Test Routine – DT400
Check the DT400's keys, lamps and LCD display.