Vulcan-Hart C24EA3 Service Manual page 10

LATCH ASSEMBLY
Removal and Disassembly
1. Separate outer door housing assembly from
inner door panel as outlined under DOOR
HANDLE.
2. Remove screws securing latch assembly to
inner door panel and remove latch mechanism.
3. Remove E-clip from latch assembly pins and
pull pins from latch mechanism.
4. Remove retaining pin from spring pin.
5. Separate sliding bracket from stationary
bracket.
F25213 (May 2006)
MODEL C24EA - DOOR
Assembly
1. Apply Lubriplate 630AA to sides of sliding
bracket.
2. Insert spring pin into bottom of sliding bracket.
A.
3. Assemble sliding bracket into stationary
bracket.
4. While holding head of spring pin against bottom
of sliding bracket, insert spring pin into keeper
hole in bottom of stationary bracket.
A.
NOTE: Install pins such that heads of pins will be
facing inward toward hinge side of inner door panel
when latch assembly is installed.
5. Install pins to assemble stationary and sliding
brackets together.
A.
Installation
1. Install latch assembly onto inner door panel with
spring pin toward bottom of door panel.
A.
Page 10 of 52
Place spring over spring pin.
Secure spring pin in place with retaining
pin.
Secure pins into position with E-clip.
Apply Loctite 271 to threads of screws
before assembly and secure latch
assembly to inner door panel.