Heat & Glo TRUE-36G-IFT Installation Manual page 75

A. Vent Components Diagrams (continued)
14 IN.
356 mm
Note: Wire harnesses required to power the PVLP-SLP connect to the appliance and are ordered separately from
PVLP-SLP. Contact your dealer to order.
Note: A PVLP-HS heat shield is available and sold separately. Use if the PVLP-SLP is installed in a high tra昀케c area.
Note: The PVLP-SLP requires one of the following options to be installed on this appliance.
Option A: IFT-RC400 or Option B: IFT-RC150, IFT-ACM.
These accessories are purchased separately from the PVLP-SLP. Contact your dealer to order.
PVLP-BEK
Brick Kit
Figure 12.7 PVLP-SLP Vent Components
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
Top View
Front View
15-1/2 IN.
394 mm
8 IN.
203 mm
11-1/2 IN.
4-3/8 IN.
292 mm
112 mm
Power Vent Low Pro昀椀le
PVLP-HS
Heat Shield
6-1/4 IN.
159 mm
1-1/2 IN.
38 mm
Side View
5-1/4 IN.
135 mm
10 IN.
254 mm
PVLP-SLP
Required Wire Harness
DESCRIPTION
10 FT PV Wire Harness
20 FT PV Wire Harness
40 FT PV Wire Harness
60 FT PV Wire Harness
80 FT PV Wire Harness
100 FT PV Wire Harness
2-1/4 IN.
57 mm
4-3/4 IN.
121 mm
9-1/2 IN.
241 mm
2-1/4 IN.
57 mm
PART NUMBER
PVI-WH10
PVI-WH20
PVI-WH40
PVI-WH60
PVI-WH80
PVI-WH100
75