Heat & Glo TRUE-36G-IFT Installation Manual page 66

6 6
Figure 10
Log #6 (SRV2282-746): Place Log #6 into left side of appliance as shown in Figure 11. Base of log will sit on bottom refrac-
tory and notch on log will rest against grate tine. Lean top of log into notch on Log #1. See Figure #2.
Figure 12
Log #7 (SRV2281-747): Place Log #7 into the right side of appliance as shown in Figure 12. The right side of the log should
contact the refractory on the right side of the 昀椀rebox. The bottom end of Log #7 should be placed four inches from the front edge
of the base refractory.
Log #9 (SRV2168-745): Place Log #9 into appliance as shown in Figure 13. Place log so that the wide end rests on Log #7 and
contacts the refractory on the right side of the 昀椀rebox just in front of the air intake port. The narrow end of Log #9 should contact
Log #1.
66 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. Y • 6/23
NOTCH NOTCH
7 7
7 7
7 7
4 IN. 4 IN.
LOG RESTS IN NOTCH ON LOG #1 LOG RESTS IN NOTCH ON LOG #1
6 6
LOG CONTACTS LOG CONTACTS
GRATE TINE GRATE TINE
LOG RESTS ON LOG RESTS ON
BOTTOM REFRACTORY BOTTOM REFRACTORY
Figure 11
9 9
WIDE END OF LOG WIDE END OF LOG
#9 CONTACTS RIGHT #9 CONTACTS RIGHT
REFRACTORY REFRACTORY
Figure 13
REAR GRATE TINE REAR GRATE TINE
7 7