EIBENSTOCK EBM 250/2 RP Original Instructions Manual page 5

Overhead-drillings only with suitable safety measures (water collection).

After an interruption of your work, only switch the machine on again

after having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.

Do not touch rotating parts.

Persons under 16 years of age are not allowed to use the tool.

During use, the user and other persons standing nearby have to wear

suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when

you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
98
79,5
The EBM 250/2 RP is made in protection class I. In order to protect the
operator, the machine can only be run with a GFCI. For this reason, the
machine is standard equipped with a PRCD switch integrated in the cord
which allows to connect the unit directly with a grounded socket.
Attention!
! The PRCD-safety switch must not lay in water.

PRCD-safety switch must not be used to switch the tool

on and off.
Before you start working, check the proper functioning by

pressing the TEST button.
Fasten the gearing foot of the
EBM 250/2 RP by means of four M 8
Allen screws to the drill rig.
The drill stand should have a good
stiffness and precise guide ways. The
spindle of the machine needs to go
parallel to the axle of the drill stand.
Use only fall-safe drill rigs.
It is advisable to use a water-collecting
ring.
Electrical Connection
5