Multiple Volumes
There are many combinations of volumes and RAID configurations available on your LaCie NAS. While this
manual cannot list every single option, you can use the steps below as a guide when you set up multiple
volumes on your pool of storage.
This example will demonstrate the creation of two volumes using RAID 0 (performance) and SimplyRAID
(protection). To add greater performance to this configuration, the administrator can bond the two Ethernet
ports and create an iSCSI target on the RAID 0 volume. See
A router that supports port aggregation is required for Ethernet bonding.
Create the first volume:
1.
If you have not inserted the hard drives into the LaCie 5big NAS Pro, please see
for basic instructions. For a full explanation of adding disks to the enclosure, see
Diskless LaCie 5big NAS
2.
Choose Add storage.
3.
Select Network volume and choose Next.
LaCie 2big NAS | LaCie 5big NAS Pro User Manual
Pro.
Network
and
iSCSI Target
for additional instructions.
Remove/Insert a Hard Disk
Connect to the Network:
295