Modem Switch Settings (At Commands) - Sun Microsystems Ultra 1 Creator Series Reference Manual

3.3.2

Modem Switch Settings (AT Commands)

Enable transmit flow control (AT&H1) [suggested setting] (Required for sending
binary/8-bit data)
Set link rate to fixed (Will not track modem data rate, AT&Bn; n = menu choice in
modem manual.)
Set display result codes (ATQ0)
Set verbal result codes (ATV1)
Set result code subset (ATXn; n = option choice)
Save settings in NVRAM (AT&W)
Note – The above settings are guidelines to help you get started quickly. Changes
to these guidelines should be expected depending on your site requirements and the
modem you are using.
For additional information about modem switch settings, see the manual that came
with your modem.
Chapter 3 Modem Setup Specifications 3-3