Troubleshooting (Motor) - MULTIQUIP PRO12C Operation Manual

Hydraulic plaster/mortar mixer, honda gx390rt2-qnb2 gasoline engine/teco westinghouse 5hp electric motor
Table of Contents

Advertisement

Symptom
Electric motor will not start.
Electric motor continuously stops.
Electric motor RPM's too low.
Electric motor RPM's too high.
PRO12C HYDRAULIC MIXER • OPERATION MANUAL — REV. #0 (07/16/20) — PAGE 33

TROUBLESHOOTING (MOTOR)

Troubleshooting (Electric Motor)
Possible Cause
Is there power?
Is power cable plugged in?
Is ON/OFF switch placed in ON
position?
Defective cable?
Reset button OK?
Low voltage?
High voltage?
Solution
Check power source. Check reset
button.
Plug in power cable.
Place ON/OFF switch in ON position.
Check cable.
Check power source.
Check input voltage.
Check input voltage.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO12C and is the answer not in the manual?

This manual is also suitable for:

Essick seriesPro12e51cPro12e53cPro12e53-460vc

Table of Contents