SHOWTEC ShowFog Pro 1000 User Manual page 5

 Always drain tank before shipping or otherwise transporting this unit.

Always keep tank cap closed while operating.
 Always keep the fog machine upright.

Always unplug your SHOWTEC Fog Machine before filling its tank.
 For adult use only. Fog machine must be installed out of the reach of children. Never leave the unit running
unattended. Leave the grid guarding the nozzle in place if the machine is to be used in the presence of
children

Always keep the nozzle at least 50 cm away from contact with anything, while in operation.

Always disconnect power from the mains, when device is not used or before cleaning ! Only handle the power-
cord by the plug. Never pull out the plug by tugging the power-cord.
 Make sure that the available voltage is not higher than stated on the rear panel.

Make sure that the power-cord is never crimped or damaged. Check the device and the power-cord from time
to time.

Make sure that the core diameter of extension cords and power cords is sufficient for the required power
consumption of the device.

The cable insert or the female part in the device must never be strained. There must always be sufficient cable
to the device. Otherwise, the cable may be damaged which may lead to deadly electrical shocks.
 If the external cable is damaged, it has to be replaced by a qualified technician.
 If device is dropped or struck, disconnect mains power supply immediately. Have a qualified engineer inspect
for safety before operating.
 If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it
has reached room temperature.

If your Showtec Fog Machine fails to work properly, discontinue use immediately. Drain all fog liquid from the
tank, pack the unit securely (preferably in the original packing material), and return it to your Showtec dealer for
service.

For replacement use fuses of same type and rating only.
 Allow time to cool down, before cleaning or servicing.

The residence time of persons in smoke-filled rooms with less than 15 m of sight must never exceed 5 minutes.

The fog vapour at point of release is under pressure and is extremely hot.
 The output nozzle becomes very hot during operation (300 degrees C). Keep flammable materials at least 50
cm away from the nozzle.

The use of smoke-fluid is only allowed for adults.

Repairs, servicing and electric connection must be carried out by a qualified technician.
 In dense, smoke-saturated surroundings, the oxygen portion is substantially reduced!
 The smoke density must be portioned in a way that the sight will always be above 5 m - Danger of anxiety state
due to missing orientation!

The user is responsible for correct positioning and operating of the
accept liability for damages caused by the misuse or incorrect installation of this device.
 Every smoke-filled room must be overseen by a skilled person.
 WARRANTY: Till one year after date of purchase.
Operating instructions:
This device is not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
The minimum distance between light-output and the illuminated surface must be more than 0,5 meters.
The maximum ambient temperature t
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
If this device is operated in any other way, than the one described in this manual, the product may suffer
damages and the warranty becomes void.
Any other operation may lead to dangers like short-circuit, burns, electric shock, explosion, crash etc.
You endanger your own safety and the safety of others
Improper installation can cause serious damage to people and property !
= 45°C must never be exceeded.
a
3
ShowFog Pro 1000. The manufacturer will not