Day And Time Setup; Set Incoming Message Length - VTech 914-916adl Operating Instructions Manual

ITAD OPERATION
1. Press MENU until you hear "Set
audible message alert."
2. Press SELECT until the desired
s e t t i n g , ( O N o r O F F ) i s
announced.
3. Press SET/CLOCK to confirm
your choice. The voice prompt of
"Audible Message Alert On" or
"Audible Message Alert Off" will be
produced.

Day and Time Setup

During initial setup, or after a power
failure, the day and time default is set
to Monday 12:00am. The FULL LED
will flash to indicate day and time need
to be set.
900
MHz CORDLESS
914ADLi
DAY AND TIME SETUP
1.Press
MAILBOX
2.Press
3.Press
SET/CLOCK
SELECT MENU
RECORD/
MEMO
ANSWER
4.Press
ON
SCREEN
5.Press
ON
6.Press
7.Press
PLAY SKIP
REPEAT STOP
PAGE
1. Press MENU until you hear, "Set
day and time."
2. Press SELECT until the desired
day is announced.
3. Press SET/CLOCK to confirm
your choice. You will hear a beep
followed by an announcement of
the current hour setting.
4. Press SELECT until the desired
hour is announced.
5. Press SET/CLOCK to confirm
your choice. You will hear a beep
followed by an announcement of
the current minute setting.
6.
7.

Set Incoming Message Length

The incoming message length can be
programmed to 30, 60, or 90 seconds.
Also, the ITAD can be set to Announce
Only; i.e. it does not allow the caller to
leave any messages.
To set the Incoming Message Length:
1.
2.
MEMU 5 Times
SELECT
SET/CLOCK
3.
SELECT
SET/CLOCK
SELECT
SET/CLOCK
4.
5.
MAILBOX
SET/CLOCK
RECORD/
MEMO
SCREEN
EPEAT STOP
27
Press SELECT until the desired
minute is announced. Holding the
SELECT key continuously will
increase the minute in 10 minute
steps.
Press SET/CLOCK to confirm your
choice. You will hear a beep,
followed by an announcement of
the day and time.
Press MENU until, "Set incoming
message length" is announced.
Press SELECT until the desired
setting - "30 seconds", "60
seconds", "90 seconds", or
"announce only" is announced.
Press SET/CLOCK to confirm the
setting. The selected choice will
then be announced.
If the incoming message is set to
30, 60, or 90 seconds, the ITAD
will use OGM1 only.
If the incoming message length is
set to "announce only", the ITAD
will use OGM2 only.
900
MHz CORDLESS
914ADLi
SET INCOMING
MESSAGE LENGTH
OR ANNOUNCE ONLY
SELECT
MENU
ANSWER 1.Press MEMU
ON
ON
2.Press SELECT
3.Press SET/CLOCK
PLAY SKIP
PAGE
6 Times