Wall Mounting - VTech 914-916adl Operating Instructions Manual

WALL MOUNTING

1. Choose a spot near an electri-
cal outlet and a telephone jack.
Your phone requires a modular
telephone jack and a standard
electrical outlet (120v AC). The
power cord is six feet long; make
sure there is an electrical outlet
within reach of the base. The
outlet should not be controlled by
a wall switch. If the switch is ever
turned off, the phone will not
operate.
900
MHz CORDLESS
914ADLi
1 2 3
PUBLIC
FULL
MAILBOX
DIGITAL
ANSWERING
DEVICE
POWER
IN USE
ERASE
CHARGE
ON
SPARE VOL
BATT
REPEAT STOP PLAY SKIP
PAGE
WHEN
WALL MOUNTING,
AC CHOOSE A SPOT NEAR
OUTLET
THE ELECTRICAL OUTLET
AND TELEPHONE JACK.
TELEPHONE
JACK
2. Position the wall mount adapter
on the base. Line up the tabs on
the wall mount adapter with the
holes on the bottom of the base.
Snap the wall mount adapter firmly
in place.
INSERT WALL
MOUNT INTO THE
BASE UNIT
SNAP IN FIRMLY
3. Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the wall
the phone is to be mounted on.
Slide the base down on the mount-
ing studs until it locks into place.
4. Connect the telephone cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on
the bottom of the base. Insert the
other end of the plug into the wall
jack.
9VDC
TEL.LINE
AC
ELECTRICAL
OUTLET
11
PUSH IN
and
SLIDE DOWN
TELEPHONE
WALL
JACK