Before The Installation Of The Wires - Husqvarna AUTOMOWER 435X AWD Operator's Manual

CAUTION: Do not put the guide
wire in parallel with the slope, as
the illustration shows. This can
increase the wear on the grass.
1035 - 001 - 04.02.2019
3.2.5 Work area examples
D
B
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 3 m / 10 ft.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.5 ft. If the passage is
smaller than 2 m / 6.5 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by small passages (C), you can
change the settings of Lawn Coverage.
Lawn coverage on page 27 .
Refer to
• If the work area includes a secondary area
To make a secondary area on
(D), refer to
page 18 . Put the product in the secondary
Secondary area mode , refer
area and select
Secondary area on page 30 .
to

3.3 Before the installation of the wires

You can select to attach the wires with stakes or
bury them. You can use the 2 procedures for the
same work area.
A
C
Installation - 19