Husqvarna AUTOMOWER 435X AWD Operator's Manual page 27

®
• With the Automower
®
the Automower Connectapp on your
mobile device. Go to
height and obey the instructions in the app.
The cutting height can be varied from MIN (3 cm /
1.2 in.) to MAX (7 cm / 2.8 in.).
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
3.15.3 Operation
Operation you can change the
In
operation settings of the product. To
change the settings, obey the
instructions in the Automower
Connect app.
3.15.3.1 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.15.4 Installation
Installation you can change the
In
installation settings of the product. To
change the settings, obey the
instructions in the Automower
Connect app.
3.15.4.1 Find charging station
The product has 2 search methods to find the
charging station:
• Charging station signal - The product moves
in the work area until it finds the signal of the
charging station.
1035 - 001 - 04.02.2019
Connect app. Open
Settings > Cutting
®
®
• Guide wire - The product moves in the work
area until it finds the guide wire. The product
moves along the guide wire to the charging
station.
The factory setting is set to mix the 2 search
methods. When the battery is low the product
starts to search for the charging station signal.
The strength of the charging station signal can be
changed in the Automower
specified time delay the product changes search
method to the guide wire method. The time delay
can be changed in the Automower
app.
3.15.4.2 Lawn coverage
Lawn coverage function is used to move the
The
product to remote parts of the work area. You
can divide your lawn into 5 areas. For each area
you can set:
• which guide wire the product should follow.
• the distance from the charging station to the
remote area.
• how frequently the product should operate in
the remote area.
3.15.4.3 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
Drive Past Wire function
factory setting for the
function is 31 cm. You can select a distance of
20-50 cm.
3.15.4.4 Starting point
The Starting point function allows you to control
how far the product drives forward from the
charging station before it starts to operate. Use
this function if the charging station is placed in an
area with limited space, for example under a
veranda.
3.15.5 Accessories
Accessories you can change the
In
settings of the product accessories. To
change the settings, obey the
instructions in the Automower
Connect app.
3.15.5.1 Headlights
Headlight settings
There are 4 different headlight settings that
control when the headlights are on:
®
Connect app. After a
® Connect
®
Installation - 27