Electrolux LKI6444NOW User Manual page 39

Table of Contents

Advertisement

Problem
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
Residual heat indicator does not
come on.
Automatic Heat Up function does
not operate.
Automatic Heat Up function does
not operate.
The heat setting changes between
two levels.
The sensor fields become hot.
There is no signal when you touch
the panel sensor fields.
comes on the hob display.
comes on the hob display.
comes on the hob display.
comes on the hob display.
comes on the hob display.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
The display shows F11.
Steam and condensation settle on
the food and in the cavity of the
oven.
There is no good cooking perform‐
ance using the Steam Bake func‐
tion.
Possible cause
You put something on one or more
sensor fields.
The zone is not hot because it oper‐
ated only for a short time.
The zone is hot.
The highest heat setting is set.
Power management function oper‐
ates.
The cookware is too large or you put
it too near to the controls.
The signals are deactivated.
Automatic Switch Off operates.
The Child Safety Device or the Lock
function operates.
There is no cookware on the zone.
The cookware is incorrect.
The diameter of the bottom of the
cookware is too small for the zone.
The oven is deactivated.
The clock is not set.
The necessary settings are not set.
The lamp is defective.
There was a power cut.
The plug of the core temperature
sensor is not correctly installed into
the socket.
You left the dish in the oven for too
long.
You did not fill the cavity emboss‐
ment with water.
Remedy
Remove the object from the sensor
fields.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Refer to "Hob - Daily use" chapter.
Put large cookware on the rear
zones if possible.
Activate the signals. Refer to "Hob -
Daily use" chapter.
Deactivate the hob and activate it
again.
Refer to "Hob - Daily use" chapter.
Put cookware on the zone.
Use the correct cookware. Refer to
"Hob - Hints and tips" chapter.
Use cookware with correct dimen‐
sions. Refer to "Hob - Hints and
tips" chapter.
Activate the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
Replace the lamp.
Reset the clock.
Put the plug of the core temperature
sensor as far as possible into the
socket.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Refer to "Activating the Steam Bake
function".
ENGLISH
39

Advertisement

Table of Contents
loading

Table of Contents