Electrolux LKI6444NOW User Manual page 36

12.4 Catalytic cleaning
CAUTION!
Do not clean the catalytic surface with
oven sprays, soap or other cleaning
agents. It will damage the catalytic
surface.
CAUTION!
Always turn the oven light on while using
the catalytic cleaning (if applicable).
WARNING!
Keep children away when you clean the
oven at a high temperature. The oven
surface becomes very hot and there is a
risk of burns.
Spots or discolouration of the catalytic
surface have no effect on catalytic
properties.
Before activating the catalytic cleaning
remove all the accessories from the
oven.
The walls with catalytic coating are self-
cleaning. They absorb fat which collects on
the walls while the appliance operates.
To support the self-cleaning procedure, heat
the empty oven on a regular basis.
1. Clean the oven floor with warm water and
washing-up liquid, then dry it.
2. Set the function.
3. Set the oven temperature to 250 °C and
let the oven operate for 1 hour.
4. When the appliance is cool, clean it with a
soft and moist sponge.
12.5 Cleaning the cavity
embossment
The cleaning procedure removes limestone
residue from the cavity embossment after
cooking with steam.
36 ENGLISH
For the function: Steam Bake we
recommend to do the cleaning procedure
at least every 5 - 10 cooking cycles.
1. Put 250 ml of white vinegar into the cavity
embossment at the bottom of the oven.
Use maximum 6% vinegar without any
additives.
2. Let the vinegar dissolve the residual
limestone at the ambient temperature for
30 minutes.
3. Clean the cavity with warm water and a
soft cloth.
12.6 Removing the shelf supports
To clean the oven, remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer fixing wire is in
the front. The ends of the two wires must
point to the rear. Incorrect installation can
cause damage to the enamel.
2