Putting Into Service; Air Supply - Stanley 07535 MKII Instruction Manual

E N G L I S H

4. PUTTING INTO SERVICE

4.1 AIR SUPPLY

All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators
and automatic oiling/fi ltering systems on the main air supply. To ensure maximum tool life and minimum tool maintenance
they should be fi tted within 3 metres of the tool (see diagram below).
Air supply hoses should have a minimum working eff ective pressure rating of 150% of the maximum pressure produced
in the system or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and
should be armoured where operating conditions may result in hoses being damaged. All air supply hoses MUST have a
minimum bore diameter of 6.4 millimetres or 1/4 inch.
Read daily servicing details page 11.
Follow the steps below when connecting the tool to the intensifi er and main air supply:
• Push the end of the larger hose from the tool into the quick release connector on the end of the intensifi er.
• Push the smaller hose from the tool into the plastic collet of the bulkhead connector on the front face of the intensifi er.
• Fit a hose between the male connector at the rear of the intensifi er and the main air supply.
8
STOP COCK
(USED DURING MAINTENANCE
OF FILTER/REGULATOR OR
LUBRICATION UNITS)
LUBRICATOR
PRESSURE REGULATOR
AND FILTER (DRAIN
DAILY)
O R I G I N A L I N S T R U C T I O N
TAKE OFF POINT
FROM MAIN SUPPLY
MAIN SUPPLY
DRAIN POINT