Cursor; Loading And Reloading The Tool - Stanley 07535 MKII Instruction Manual

O R I G I N A L I N S T R U C T I O N

4.2 CURSOR

If fi tted incorrectly, the cursor will not allow feeding of the fasteners.
While the cursor will be fi tted the correct way round when the tool is supplied, we recommend that you check its orientation
before fi tting the nose equipment. The sprung loaded, slightly concave, end of the cursor should point towards the front of
the tool as shown in the illustration.
When fi tted the correct way round, the cursor will easily slide out of the barrel when a mandrel is pushed into its centre then
pulled back.
To reverse the orientation of the cursor, follow these steps:
Item numbers in bold refer to the general assembly and parts list for the
07535-02500 MkII type on pages 15 and 16.
• Remove the Clip 46 and slide off End Cap 38.
• Using an Allen Key, remove one cap head screw 43 ensuring that
any trapped air is exhausted. Remove the second Cap Head Screw 43.
• Pull out Rear Plug 45.
• Pull out Tail Jaw Piston Assembly 14 together with Jaws 9.
• Lift out Spring 13 and Jaw Housing 8.
• Insert a mandrel into the hole in the rear end of Barrel 25 until it protrudes through the front of the barrel, then pull out
the mandrel and cursor together through the front.
• Reassemble components in reverse order.
• Insert Mechanical Cursor Assembly 5 into the front of the barrel, correct way round.

4.3 LOADING AND RELOADING THE TOOL

The procedure for loading the tool and for fi tting the nose equipment to the tool is integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the
fastener to be placed.
To identify nose equipment components or to select the correct elements, read the nose equipment section, in the
accessories manual (07900-09508).
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fi tting
the nose equipment as shown overleaf.
Item numbers in bold refer to the general assembly and parts list for the 07535-02500 MkII type on pages 15 and 16.
IMPORTANT
LOADED END
IMPORTANT
CURSOR
SPRING
NOSE
JAWS
E N G L I S H
TOOL
BARREL
9