Dalsa Piranha4 User Manual page 95

Full Name Load Pixel Coefficients
Mnemonic LPC
Argument(s) Set selector
Description Load user set
•
Notes
Full Name Reset Camera
Mnemonic RC
Argument(s)
Description Resets the camera to the saved user default settings. These settings are saved using the
usd command.
Notes The micro-controller reboots:
•
•
•
•
•
•
•
Full Name Set Flatfield ROI
Mnemonic ROI
Argument(s) First pixel
Last pixel
Description Flat field region of interest
•
Notes
•
Full Name Reset Flatfield Coefficients
Mnemonic RPC
Argument(s)
Description Reset all user FPN values to zero and all user PRNU coefficients to one
Notes
Loads FPN coefficients and PRNU coefficients from a user set ( only
coefficeints, no other camera parameters)
Load any file updates
Clear over temperature condition
Perform start up camera tests (BiST)
Load FPGA code
Configure FPGA and sensor.
Load default user set
Baud rate set to 9600
Specifies the pixels that CCF and CPA will calibrate
o
Pixel coefficients outside this region are not changed
Last pixel must be greater than or equal to first pixel
0. Factory set
1-8. User sets
1 to 8192
1 to 8192