Advertisement
Table of Contents
MODEL MDA20U
Fully Shielded & F type Masthead
distribution amplifier
LED
WaRRanty
Standard Communications
Kingray product to be free from defects in material
and workmanship for a period of 3 years from the
Standard Communications
A Division of
Head Office: Locked Bag 2086, North Ryde N.S.W. 1670. P: +61 (0)2 9844 6666, f: +61 (0)2 9844 6600
Sydney
MelbouRne
P: (02) 9879 8888
P: (03) 9798 0988
F: (02) 9816 4722
F: (03) 9798 0177
E: nswbrch@gme.net.au
E: vcbrch@gme.net.au
Installation ManUal
warrants this
PTY. LTD
PTY. LTD.
bRISbane
P: (07) 3278 6444
F: (07) 3278 6555
E: qdbrch@gme.net.au
Optimised for both Digital and
Analogue TV Signal Amplification
Thank you for selecting an Australian designed and built
F Type masthead amplifier.
• M ount with polypropylene securing strap
on to mast or mount to a wall with the four
pre-drilled holes.
• B est mounting location for masthead unit is
on mast 300 mm to 1 metre below antenna.
• E nsure weatherproof strips remain in place.
date of installation and reserves the right to void
warranty if unit was misused, improperly installed or
damaged by claimant.
adelaIde
P: (08) 8234 2633
F: (08) 8234 5138
E: sabrch@gme.net.au
www.gme.net.au
PeRth
auCkland
P: (08) 9455 5744
P: (09) 274 0955
F: (08) 9455 3110
F: (09) 274 0959
E: wabrch@gme.net.au
E: nzbrch@gme.net.au
Advertisement
Table of Contents
Related Manuals for Kingray MDA20U
Summary of Contents for Kingray MDA20U
- Page 1 PTY. LTD Kingray product to be free from defects in material warranty if unit was misused, improperly installed or and workmanship for a period of 3 years from the damaged by claimant.
- Page 2 GENERAL INFORMATION The MDA20U amplifier is based on a new concept of convergent technology. The characteristics of the IC selected provide a noise figure that is lower than any other product currently on the market and an output figure that surpasses most distribution amplifiers hence the name Masthead Distribution Amplifier (MDA).
- Page 3 inSTallaTiOn The head of the amplifier may be mounted outside on the pole under the antenna or in the roof. The amplifier requires F type connectors. The power supply unit is placed at a television outlet, or at a remote location, a low voltage then runs up the cable to power the head remotely, via the output.
Need help?
Do you have a question about the MDA20U and is the answer not in the manual?
Questions and answers