Dry Ironing; Steam Ironing - Silvercrest SDBT 2400 A1 Operating Instructions Manual

■ When you take your hand off the handle
activated and the steam iron stops heating. The hand indicator LED
flashing, and the iron soleplate
ture. As soon as you hold the steam iron by the handle
Note
► The automatic switch-off is not intended as a substitute for removing the plug
from the mains power!
It is only used to avoid unnecessary power consumption and to reduce the
risk of fire when the steam iron is still connected to the mains socket.

Dry ironing

ATTENTION!
► Only use the steam iron for dry ironing damp and heat-resistant cotton or
linen clothing. Ignoring this warning could lead to permanent damage to the
clothing item.
1) Slide the steam control
2) Allow the steam iron to heat up until the heat indicator LED
continuously.
3) Start ironing.

Steam ironing

ATTENTION!
► If the care instructions in the garment prohibit steam ironing (see table in
section Care instructions), do not steam iron the garment. Ignoring this
warning could lead to permanent damage to the clothing item.
1) Set the steam control
–
middle position: less steam
–
lowest position : more steam
2) Allow the steam iron to heat up until the heat indicator LED
continuously.
3) Steam comes out of the soleplate
horizontally. Start ironing.
SDBT 2400 A1
7
q
slowly cools down to ambient tempera-
3
all the way up to position 0 (no steam) (see Fig. 2).
3
to the desired steam setting:
q
as soon as you hold the steam iron
the automatic switch-off is
7
, it heats up again.
8
lights up
8
lights up
GB │ IE │
6
starts
13 ■