Filling The Water Tank; Plugging In And Ironing - Silvercrest SDBK 2200 A1 Operating Instructions Manual

Filling the water tank

• In a cooled condition, place the steam iron
horizontally on its ironing sole e.
• Slide off the cover of the filler opening for the
water tank 2.
• Using the measuring beaker, fill the water tank
with water to the "Max" marking, but no further.
• Slide the cover of the filler opening for the water
tank 2 back to close it.
Note:
Should the mains water at your locality be rated as
hard, it is recommended that you mix mains water
with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked)
prematurely.
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table.
Water hardness
very soft / soft
medium
hard
very hard
The water hardness level can be queried at your
local water works.
Ratios - distilled
water to mains
water
0
1 : 1
2 : 1
3 : 1

Plugging in and ironing

Dry ironing without steam is possible at all temperatures,
steam ironing is first possible from the adjustment
on the temperature regulator 7.
range
• Insert the plug into a power socket.
Attention!
Should the clothing care instructions forbid ironing,
(Symbol ), the clothing item may not be ironed.
If you do so, the clothing item could be permanently
damaged.
• Check the care instructions on the labels in the
garment to see if it is suitable for being ironed,
and at which temperature setting.
Symbol
Temperature
regulator 7
• Select the best suitable temperature setting with
the temperature controller 7.
The control lamp for the temperature 6 glows.
When the set temperature has been reached, the
temperature control lamp 6 goes out.
• Wait until the temperature control lamp 6
extinguishes.
• To moisten the laundry, press the spray button 4.
This function is suitable for very dry and very crumpled
garments.
- 7 -
Type of Material
Acrylic, rayon
Silk, wool, polyester
blended fabrics
Cotton, linen, viscose