Advertisement
SECTION
1:
WARNINGS
Inspect the burner
when
it arrives at fts shipping destination
to
identify and record any
shipping damage. Reporting this damage to the carrier is the responsibility of the consignee
and
SUCH DAMAGE
IS
NOT COVERED
BY
THE
WARRANTY. Refer
to Section 3 for
more details.
If
the
burner is stored prior to installation. it is
the
responsibility of others (not York-Shipley)
to provide. the necessary protection from damage due to conditions such as:
•
Freezing temperatures
•
Flooding
Dust and
dirt
Falling articles.
etc.
SUCH DAMAGE IS NOT COVERED BY THE
WARRANTY
(see Section 3)
.
It Is
the
owner's responsibility
;
in cooperation with
the
installer,
to
obtain the required
inspections of the installation for compliance with state and local jurisdictional codes and
requirements and to obtain boiler insurance, operating certification and periodic third-party
inspections during the life of the burner.
The
owner has the responsibility to provide qualified and trained operators and to assure that
the
burner
is operated and
maintained
to provfde efficient and safe operation
.
This
manual
provides information to assist the owner and operators but is not intended to supplant
thoughtful and diligent dedication on the part of
the
owner and operators to this task. The
owner and operators must comply
with the
regulations and requirements of the insurance
carrier, and state and local
jurisdictions.
Their
legal requirements
take
precedence over
anything included in this
manual.
The burner
~:1i
iizes
combustible fuels and
water
or
steam
at pressures higher than
atmospheric. Industry accepted safety standards are met or exceeded in the design and
manufacture of
the
burner.
INSTALLERS
AND
OPERATORS
OF THE
BURNER
ARE
WARNED THAT THEIR IMPROPER OR CARE
LESS ACTIONS
CAN RESULT IN A
HAZARDOUS CONDITION.
The equipment is not intended for use in furnishing temporary heat to
the
structure in
which
it
is installed
prior to
the completion and acceptance
of
such structure and installation by
the
owner or other
person
for
whom
the entire project is
being
constructed. Therefore, the
warranty
and
warranty
service
normally
issued
with
respect to
this
equipment
will
not apply
during
and after
such use.
WHEN SERVICING THE
BURNER,
DISCONNECT ALL POWER
SUPPLIES.
Equipment
furnished by
York-Shipley Global
includes
various
safety,
performance,
temperature
and
operation systems and limits.
ANY ACTIONS BY THE
PURCHASER,
PURCHASER
'
S
PERSONNEL
OR
PERSONS
ACTING
ON
PURCHASER
'S
BEHALF WHICH TEND TO NULLIFY OR CHANGE SUCH SYSTEMS OR LIMITS
WILL BE TAKEN AT
PURCHASER'S
SOLE RISK AND RESPONSIBILITY AND
WILL
VOID
York-Shipley Global's
WARRANTY
AND
PERFORMANCE RESPONSIBILITIES
AND
WILL RELIEVE
York-Shipley
OF ALL LIABILITIES RESULTING THEREFROM.
Section
1 -
Warnings
Advertisement
