Table of Contents
Advertisement
3.
Lift the right side of system board (1), and then pull the system board right and away from the
connectors to remove it from the computer (2). You can remove the USB bracket (3) after removing
the system board.
To install the system board, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE:
The display assembly is spared at the subcomponent level. For display assembly spare part
information, see the individual removal subsections.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Disconnect the camera cable (1) from the system board ZIF connector.
2.
Disconnect the WLAN antenna cables (2) from the terminals on the WLAN module.
3.
Release the display cable from the retention clips (3).
44
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
29).
Battery on page
30).
29).
Advertisement
Table of Contents
