Set Time / date
Note
A6V11545892_en--_e
Energy-efficient setting
Set TIME
WARNING
Time synchronization via bus (RDG2..KN)
Time of day and date information are received from a Synco controller with time
manager function (RMB, OWZ, etc) or any other KNX device e.g. GPS clock, if
the corresponding communication object is bound.
The scheduler function must be enabled before setting the time of day:
●
Press
once and then turn the rotary knob or press
programming mode TIME.
●
Press
once and then turn the rotary knob to select the time format.
●
If 12H is selected, press
PM.
●
Press
once and enter the hour setting.
●
The hour value flashes and can be changed by turning the rotary knob.
●
Press
once to confirm the adjusted value and enter the minutes setting.
Repeat the steps as for the hour.
●
AM/PM does not display when set to 24 hour clock.
●
Power reserve clock for 20 h during power failure (RDG2..T)
Exceed the preset energy-efficient
range
Touch to reset user setting
once and then turn the rotary knob to select AM or
4
Functions
Additional functions
continuously to select
59 | 186