Table of Contents
Advertisement
Overview difference between KNX (RDG2..KN) and standalone (RDG2..T) versions
Functions
KNX communication related
functions
Power switch (RDG2..KN)
Functional input/output
Application
Time clock
Others
A6V11545892_en--_e
●
M/S - manager/subordinate alarm management via LTE-Mode allowing for
subordinate alarm display on the manager
●
Display of outside temperature, humidity, CO
●
Time scheduling and central control of setpoints from KNX bus
●
Control of Economy setpoints via KNX bus
●
Relative humidity setpoint via KNX bus
●
Control of KNX actuators and fan via S-Mode objects
●
Energy supply optimization via energy demand signal via Synco RMB795B
central control unit
●
Interworking with Siemens AQR.. and QMX.. sensors for room humidity, room
temperature and CO
●
Interworking with Siemens QMX.. room operator units for room humidity, room
temperature and operating commands for fan, operating mode and setpoints
●
Commissioning KNX area, line and device address via mobile application PCT
Go
Descriptions
●
Communicating thermostat [➙ 118]
●
Commissioning via ETS, ACS [➙ 22]
●
Manager/Subordinate [➙ 65]
●
Power switch AC 230 V / AC 24 V [➙ 47]
●
Support AC 24 V 2-pos/3-pos actuators [➙ 14]
●
Functional input/output U1 [➙ 115]
●
Multifunctional input X3 (sensor, switch) [➙ 115]
●
Monitor input for temperature sensor or switch status
[➙ 115]
●
4-pipe/2-stage [➙ 88]
●
Power reserve clock for 20 h during power failure
[➙ 76]
●
Humidity [➙ 60]
●
Indoor air quality control [➙ 69]
●
Greenleaf indication [➙ 57]
measurement
2
Overview
Functions
or time of day from KNX bus
2
KNX Standalone
✓
✓
✓
✓
✓
✓
✓
✓
2
✓
✓
13 | 186
Advertisement
Table of Contents
