10. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note:
•
To avoid milk with poor froth or large bubbles, always clean
the milk container lid (D2) and hot water connection noz-
zle (A8) as described in sections "10.4 Cleaning the milk
container after use", "13.10 Cleaning the milk container"
and "13.11 Cleaning the hot water nozzle".
10.1 Filling and attaching the milk container
1. Remove the lid (D2) (fig. 14);
14
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the contain-
er (fig. 15). Each mark on the side of the container corre-
sponds to 100ml of milk;
Please note:
•
For a denser and more evenly distributed froth, always use
skimmed or partially skimmed milk at refrigerator tem-
perature (about 5 °C).
•
If "Energy Saving" mode is enabled, you may have to wait a
few seconds before the first cappuccino is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
the bottom of the milk container lid (fig. 16).
16
4. Place the lid back on the milk container;
5. Remove the hot water spout (C6) from the nozzle (A8) (fig. 17);
6. Attach the container to the connection nozzle and push
as far as it will go (fig. 18). The machine emits a beep (if
enabled);
7. Place a sufficiently large cup under the coffee spouts (A9)
and the frothed milk spout (D5). Adjust the length of the
milk spout. To move it nearer the cup, simply pull it down-
wards (fig. 19).
8. Follow the instructions below for each function.
10.2 Adjusting the amount of froth
15
Turn the froth adjustment dial (D1) to adjust the amount of froth
on the milk delivered while making cappuccinos and milk-based
coffees (fig. 20).
Dial
Description
position
No froth
Min. froth
Max. froth
17
13
18
16
20
Recommended for...
HOT MILK (not frothed) /
LATTE
LATTE MACCHIATO/
FLAT WHITE
CAPPUCCINO MIX / CAP-
PUCCINO/ CAPPUCCINO+
/ ESPRESSO MACCHIATO /
HOT MILK (frothed)
19
Need help?
Do you have a question about the ECAM35075 and is the answer not in the manual?