DeLonghi ECAM35075 Manual page 24

DISPLAYED MESSAGE
Turn froth adjustment dial
Descale
ESC to cancel
OK to descale
(∼45 minutes)
Replace filter
ESC to cancel
OK to replace
General alarm
ECO
Please wait
Descaling interrupted
Continue descaling
(∼ 45 minutes)
POSSIBLE CAUSE
The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
The machine must be descaled.
The water softener filter (C4) is exhausted.
The inside of the appliance is very dirty.
The tubes inside the milk container (D) must
be cleaned.
The water softener filter (C4) is exhausted and
must be replaced or removed.
The machine must be descaled.
Energy saving is enabled.
The appliance is warming up to the optimum
temperature
Descaling has been interrupted. The machine
must be prepared for use again.
REMEDY
Turn the froth adjustment dial to one of the
milk froth positions.
The descaling procedure described in section
"14. Descaling" needs to be performed.
Replace the filter or remove it as described in
section "16. Water softener filter".
Clean the inside of the appliance thoroughly,
as described in section "13. Cleaning". If the
message is still displayed after cleaning, con-
tact a customer service centre.
Turn the froth adjustment dial (D1) to CLEAN
(fig. 21).
Replace the filter or remove it as described in
section "16. Water softener filter".
The descaling procedure described in section "14.
Descaling" needs to be performed.
The appliance may request descaling cycles at very
short intervals. This is normal and due to the appli-
ance' s advanced control system.
To disable energy saving, proceed as described
in section "6.5 General" - "• Energy saving:"
Please wait
Press the
all the liquid in the tank.
Start the descaling cycle again from point 11 of
section "16. Descaling".
23
button. The machine delivers