Setting The Time - CDA SC020 Use And Maintenance

Setting the time

When the appliance is plugged into the electrical mains supply, or when
power is restored after a power cut, the digital display will flash 0.00.
• Touch and hold
on the display and the dot below the symbol is flashing
< >
• Touch /
To store the new time setting, wait approximately 7 seconds after the time
has been set. The dot below the
adjust the time later. To do this touch /
current time while the dot below the
Note: The oven can be operated only when you see the
shown.
You can activate the Kitchen Timer at any time, regardless of the status of
other functions. The Kitchen Timer can be set from 1 minute up to 23 hours
and 59 minutes.
To set the Kitchen Timer:
• Touch MENU
<
• Use the /
set time and Kitchen Timer symbol
Once the set time elapses, alarm will sound and the
• Touch and hold
alarm, the
Note: If no button is touched, alarm will turn off automatically after
approximately 7 minutes.
(or simultaneously touch
MENU
within 7 seconds to set the current time.
, then the display will show blinking
>
sensors to set the Kitchen Timer. The display will show the
or simultaneously touch and hold /
MENU
will be off and the display will show the current time.
<
symbol will stop flashing. You can
< >
simultaneously and adjust the
symbol is flashing.
.
>
/ ) until is shown
symbol is
icon will flash.
< >
to mute the
Instruction Manual | 11