Adjusting The Display Brightness - CDA SC020 Use And Maintenance

Adjusting the display brightness

You can adjust the display brightness 1 to 9, where 1 is the darkest and 9 is
the brightest. The brightness setting applies to an inactive control panel,
i.e. when no controls are touched for 7 seconds. You can adjust the display
brightness as follows:
• Simultaneously touch the
• Touch
MENU
settings can be accessed in sequence ton (tone) and bri (brightness).
<
• Use the / sensors to select your preferred brightness:
>
Use to select the setting from 1 to 9
<
Use to select the setting from 9 down to 1
Note: The display is at its brightest setting when active, i.e. a control was
touched within the last 7 seconds.
Night Mode
The display is automatically dimmed during the night hours 22:00 — 06:00.
<
repeatedly to select the bri (brightness) setting — the
>
>
/ sensors,
Instruction Manual | 13