Table of Contents
Advertisement
Electronic programmer/timer
This oven's electronic timer is equipped with touch control sensors.
Each registered touch of a sensor field is confirmed by a single beep.
It is advisable to keep the sensor fields clean at all times.
Setting the current time
After connection to the mains supply, or reconnection after a power
outage, the display will show '0.00' and the display will flash.
•
Press the < and > sensors simultaneously until the
shows on the display and the dot below flashes. You have
approximately 7 seconds to set the time using the < and > sensors.
Wait approximately 7 seconds and the time should be set.
•
The time can be amended at any time by following these steps.
Please note: The time must be set for the oven to work.
Setting the minute minder function
The minute minder function can be set at any time, regardless of the
state of activity of the oven. The minute minder can be set anywhere
from 1 minute to 23 hours and 59 minutes.
•
Press the menu sensor until the display shows the flashing (
symbol.
•
Set the desired duration of the minute minder using the timer
left and right sensors. After an approximately 7 second wait, the
minute minder will be set and the (
minute minder duration will be shown on the timer display.
•
Press and hold any of the three sensors in order to deactivate
10
) symbol will be solidly lit. The
symbol
)
Advertisement
Table of Contents
