Power Up - PS Audio Stellar Gold Owner's Reference Manual

Referring to Figure 2, connect the desired components to your Stellar Gold Preamplifier as
Connections
follows:
(Continued)
Connect inputs to your analog sources using the appropriate connections. There are four stereo
analog inputs, which are accessible via the balanced XLR inputs (19–22) and two single-ended
RCA connectors (10–13). Connect your sources to the appropriate inputs.
Connect outputs to your power amplifier (or other line-level component) using the appropriate
connections. The Stellar Gold Preamplifier features two output types: RCA and XLR. The RCA
connector delivers a single-ended output for compatible power
amplifiers while the XLR connector delivers a balanced signal to compatible inputs. Both can be
connected at the same time, allowing one to drive a power amplifier and the other, a subwoofer
or headphone amplifier, for example.
Please be advised that the XLR output has twice the output voltage as the RCA output. Typically
this results in 6dB louder sound through units connected via the XLR input. Care should be
taken to match levels accordingly.
Connect the AC cable into the receptacle (2) in back and plug the unit into your Power Plant or
into the wall. While the supplied cord is of good quality, it is recommended that you replace it
with a high-end power cord for optimum performance. It is also recommended that you connect
your new StellarGold Preamplifier to one of PS Audio's award-winning AC power products such
as the P12, P15, or P20 Power Plants.
Optionally, connect power amps to trigger ports (5). There are two trigger ports on the rear
panel. Each of the two trigger jacks outputs a +12V signal to connected equipment when the
Stellar Gold Preamplifier front panel standby button (1) is activated. The +12V signal will stop
when the Preamplifier is in standby mode. These trigger outputs are typically used to switch on/
off compatible power amplifiers when the Stellar Gold Preamplifier is active.
Once everything is connected, it si time to power up the Stellar Gold Preamplifier. Move the rear

Power Up

panel main power switch (14), to the ON position. We recommend the master power switch be
left in the On position and AC power continue to be supplied even when the preamplifier is not in
use. Use the front panel standby/operate mode switch (1) instead of the main power switch. This
keeps power on to critical circuitry thereby avoiding the stabilizing warmup period and additional
wear on components due to power cycling.
PS Audio® Inc. 800-PSAUDIO 4865 Sterling Drive Boulder, Colorado 80301
Quick Start Guide
©2023 PS Audio Inc. All rights reserved.
Stellar Gold Preamplifier
Owner's Reference
3