Transportation, Storage And Disposal - Husqvarna DC 900 Operator's Manual

Error code
oSF
SCF1
SCF5
PHF
uSF
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
• Make sure that the electrical cable and
dust extraction hose are disconnected before
transportation. Close the air intake when the dust
extraction hose is disconnected.
• Remove the collected dust before transportation.
• The wheels let you move the product shorter
distances. For longer distances, lock the wheels and
lift the product to move it or put the product on a
vehicle.
• Put some type of protection on the product during
transportation. The protection keeps rain and snow
away from the product.
• Make sure that there is no pressure in the pressure
tank before transportation.
To move the product
WARNING:
are stationary before you move the product.
2154 - 002 - 25.10.2023
Cause
The mains voltage is too high.
There is a disturbance in the mains
supply.
There is a short circuit or grounding
at the drive output.
A phase is missing.
The mains voltage is too low.
The mains voltage is not constant.

Transportation, storage and disposal

Be careful during
Do not tow the product
Wait until all moving parts
Solution
Do a check of the mains voltage.
Do a check of the cables between
the drive and the motor. Do a check
of the ground connections and insu-
lation of the motor.
Do a check of the power supply and
the fuses.
Use a 3-phase mains supply.
Do a check of the mains voltage.
WARNING:
steel toe-cap and non-slip sole.
• Push or pull the product by the handle.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
• To move the product down a ramp, operate the
product forward slowly.
• To move the product up a ramp, operate the product
rearward slowly.
• Do not turn the product to the left or to the right more
than 45° on a ramp.
To lift the primary unit
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
Use protective boots with
Be very careful when you
For ramps with a steep
Make sure that the lifting
21