Table of Contents
Advertisement
4. CONTROLS
If you have logged in as System Administrator you have also the possibility to set values in
Manual mode for testing purpose. When the data point is in Manual mode a hand icon will
be shown in front of the data point and the data point will also be shown in the menu Points
in Manual.
It is very important to set back the data point to automatic after testing!
As the operator of the unit you should normally not change a point from Auto mode
into Manual mode. This should only be done by professional service technicians!
4.6.3 Settings
In this menu you will find the most important settings for the controller.
Here you can change the language, the date, the time and the time zone. To change the
settings no password is needed. You can chose between most of the European languages,
but the names of data points and the description of them will stay always in English.
4.6.4 Information
Under Information you can find mostly information's about the controller's software some for
example which program and firmware version is used, which IP address the controller has,
serial number and much more.
28
Advertisement
Table of Contents
