Table of Contents
Advertisement
4. CONTROLS
4.4.3.1 Set Point change
To enter one of the set points, highlight it and press the Rotate button. You will enter the
following display now:
Push the Rotate button and you can now change the value by turning the Rotate button
and then push the button again. Now the set point is changed.
4.4.4 Unit Status Menu
When Unit Status is highlighted, press the Rotate button to see following display:
Here you will find the following unit status points (Scroll down with the Rotate button):
•
Unit_Status (Actual status of the Unit)
•
Common Fault (Actual fault status)
•
Room_Temperature (Actual pool room air temperature)
•
Room_Humidity (Actual pool room humidity)
•
Supply_Air_Volume (Actual supply air volume)
•
Return_Air_Volume (Actual return air volume)
•
Supply_Air_Temperature (Actual supply air temperature)
•
Outdoor_Air_Temperature (Actual outdoor temperature)
•
Evaporator_Temperature (Actual temperature on the evaporator surface, only on heat
pump units)
•
Compressor_Status (Actual status of the compressor, only on heat pump units)
•
Compressor_Test (Compressor test function)
•
Compressor_Stop (Compressor stop function)
•
HP_LP_Alarm (Status of the HP/LP pressure switch)
•
WCC_Pump (Actual status if pump is running, only on units with WCC)
•
WCC_Heat_Demand (Water heating needed or not, only on units with WCC)
•
Heating_Signal (Actual position of heating coil actuator, signal to electrical heating coil)
21
Advertisement
Table of Contents
