Alarms; Alarm Menu; Points In Alarm; Alarm List - Dantherm DanX 1 XD User Manual

4. CONTROLS

4.5 Alarms

If there is a current alarm and the unit has stopped, the actual alarm will be shown in the
display like this compressor overload.
When the unit has stopped, because of a critical fault you have to do the following:
•
Switch off the unit at the repair breaker.
•
Locate the fault and correct it (see chapter 4.2).
•
Switch on the unit again and see if the alarm has switched over to normal again.

4.5.1 Alarm menu

Under this icon you have the following possibility:
•
See Points in Alarm
•
See Alarm List
•
See Alarm Status of LED

4.5.1.1 Points in alarm

Here all current critical and non-critical alarms can be read. The first one will be identical
with the alarm in the normal display, but there can be more alarms at the same time, which
can then only be read in this point.

4.5.1.2 Alarm list

In the alarm list, you can find the last 99 alarms with the last one on top. You can see on the
right side of the alarm at which day and when pressing the Rotate button at what time the
alarm has appeared.

4.5.1.3 Alarm status of LED

Here it is possible for the System Administrator to configure at which fault the red LED lamp
at the front of the controller should light. Standard configuration is for sensor fault and Panel
Bus error.
25