On-Vehicle Service; Propeller Shaft - Suzuki GA413 Manual

4B1-4 PROPELLER SHAFT (4WD)
1. Match mark

2. Propeller shaft

3. Joint flange

ON-VEHICLE SERVICE

PROPELLER SHAFT
REMOVAL
1) Hoist vehicle.
2) Drain transmission oil.
3) Before removing propeller shafts, give match marks (1) on each
joint flange and propeller shaft as shown.
4) Loosen propeller shaft bolts (1).
5) Remove propeller shafts.
2. AXC (if equipped)
INSPECTION
Inspect propeller shaft and flange yoke for damage, and propeller
shaft for runout.
If damage is found or shaft runout exceeds its limit, replace.
Runout limit: 0.7 mm (0.028 in.)
D Inspect constant velocity joint boot (1) for tear.
If found, replace front propeller shaft.
2. Front propeller shaft