Cellular Lock (5G) - ZyXEL Communications NR/FWA Outdoor Series User Manual

Table 27 Network Setting > Broadband > Cellular Lock (LTE) (continued)
LABEL
ACT
MNC
MCC
PhyCellID
RFCN
RSRP
RSRQ

7.11 Cellular Lock (5G)

Use this screen to configure cellular lock on Zyxel Devices that use NR (5G) connections.
To lock a base station identified by its Physical Cell ID and band, go to Network Setting > Broadband >
Cellular Lock (5G).
Note: Enabling/Disabling Cellular Lock will cause a temporary WAN disconnection.
Note: NR (5G) Cellular Lock only works when the Zyxel Device is using the NR5G-SA mode.
Make sure the Preferred Access Technology on the Network Setting > Broadband >
Cellular Band screen is set to NR5G-SA or NR5G-SA/NR5G-NSA/5G (Auto Switch).
Chapter 7 Broadband
DESCRIPTION
This shows the Access Technology (ACT) of the cell.
This shows the Mobile Network Code (MNC). MNC is a unique code that identifies a
Public Land Mobile Network (PLMN) in a country. MCC and MNC combined together
are used to identify a globally unique PLMN.
This shows the Mobile Country Code (MCC). MCC is a unique code that identifies the
country where a Public Land Mobile Network (PLMN) is at.
This shows the PCI of a cell. Use this to enter the PCI number of the base station you
choose to connect to.
This shows the RFCN (Radio Frequency Channel Number) of a cell signal. Use this to
enter the RFCN of the base station you choose to connect to. See
for more information.
This shows the RSRP value of a signal which helps you choose a network with higher
quality. See Section on page 69
This shows the RSRQ value of a signal which helps you choose a network with higher
quality. See Section on page 70
NR/FWA Outdoor Series User's Guide
95
for more information.
for more information.
Section on page 69