Configuring Tr-369 On The Zyxel Device; Mqtt - ZyXEL Communications NR/FWA Outdoor Series User Manual

Table 103 MQTT Broker Registration (continued)
ITEM
Port
TLS
QoS
Protocol Version

28.2.2 Configuring TR-369 on the Zyxel Device

First, configure the MQTT screen. Each client connecting to the same MQTT broker must have a unique
1
Client ID.
Then, configure the Agent screen. This Endpoint ID should identify the Zyxel Device acting as an agent.
2
The Alias is a friendly name for the Zyxel Device. Set the Response Topic as the topic name for the Zyxel
Device to receive USP messages from controllers. Select the Reference to be the MQTT client you
configured in the MQTT screen. For example, Device.MQTT.Client.1.
Finally, configure the Controller screen. This Endpoint ID should identify the controller. The Alias is a
3
friendly name for the controller. Set the Topic as the topic name for the Zyxel Device to publish USP
messages to the controller. For example, /usp/controller/Zyxel.

28.3 MQTT

Click Maintenance > TR-369 Local Agent > MQTT to open the following screen. Use the screen to
manage the profile settings that the Zyxel Device will use to register with an MQTT broker.
Figure 165 Maintenance > TR-369 Local Agent > MQTT
The following table describes the fields in this screen.
Table 104 Maintenance > TR-369 Local Agent > MQTT
LABEL
Add New
#
Chapter 28 TR-369
DESCRIPTION
The default port is 1883. If the broker uses a different port, you must enter that different port
number on the Zyxel Device.
If this is configured on the broker, you must also configure it on the Zyxel Device.
Note whether the broker uses QoS 0, 1 or 2, and select the same on the Zyxel Device.
Note whether the broker uses version 3.11 or 5.0, then select the same on the Zyxel Device.
DESCRIPTION
Click this button to add a new MQTT client.
Note: At the time of writing, you can add up to 128 MQTT clients.
This displays the index number of the MQTT client.
NR/FWA Outdoor Series User's Guide
245