Fitting The Welding System To A Conventional Robot; Safety; Fitting The Transsteel Welding System To A Conventional Robot - Fronius MHP 700 S R/W/PAP/FSC Operating Instructions Manual

Fitting the welding system to a conventional robot

Safety

Work that is carried out incorrectly can cause serious injury or damage.
▶
▶
An electric shock can be fatal.
Before starting the work described below:
▶
▶
▶
Risk of serious injury and damage from articles being dropped.
For all of the screw connections referred to below:
▶
▶
▶
Danger from electric current due to defective system components and incor-
rect operation.
This can result in serious personal injury and damage to property.
▶
▶
Fitting the
Individual components must be fitted to the robot in the following order:
TransSteel wel- 1.
ding system to a
conventional ro- 2.
bot
3.
4.
5.
6.
WARNING!
The following activities may only be carried out by trained and qualified per-
sonnel.
The Operating Instructions for system components, particularly the chapter
entitled "Safety rules", must be observed.
WARNING!
Turn the power source mains switch to the "O" position
Disconnect the power source from the mains
Ensure that the power source remains disconnected from the mains until all
work has been completed.
WARNING!
Check after fitting to ensure they are tight
Check following an unusual operating situation (e.g. crash) to ensure they are
tight
Check regularly to ensure they are tight
WARNING!
All cables, leads and hosepacks must always be securely connected, unda-
maged and correctly insulated.
Only use adequately dimensioned cables, leads and hosepacks.
Wirefeeder - the wirefeeder holder and the side arm holder must be fitted
first
CrashBox /i
Clamp system
Torch hosepack
Robot welding torch
Interconnecting hosepack
49