Maintenance; Safety Advice; Maintenance Plan - Virtus H 80 Series Operating Manual

PART A: Basic machine
Granulator
H 80 Series
8

MAINTENANCE

8.1

Safety advice

8.2

Maintenance plan

Maintenance work
Check protective devices for proper functioning.
Clean machine.
Check cutting knife mountings.
Check the main bearings and regrease 80g
Lubricant replacement, lubricant renewal
Check "V"-belt tension force and "V"-belt condition.
Check condition of cutting knives.
Check all screws of the machine for a tight fit.
Check wearing parts. (screen, wear plates)
 VIRTUS 2023, All rights reserved
Trained specialist personnel may only carry out work
included within the framework of maintenance.
Carry out the maintenance work within the specified time and
document this. The machine will thank you for this by
providing high reliability.
WARNING
Danger caused by electrical voltage and starting the ma-
chine during maintenance work.
Mortal danger.
Therefore, as a basic rule when carrying out maintenance
work:
Main switch to 0, safeguard using padlock and attach a
warning sign.
The tasks for maintenance work are described in detail in this
chapter.
Yearly maintenance
The purpose of yearly maintenance of the machine is primarily to
check the general condition of the machine and to arrange for the
supply of any necessary replacement parts in good time. A service
engineer from VIRTUS Equipment can also carry this out on
request.
Every day Every week Every
x
x
x
See motor manual
x
x
month
x
x
x
Page 49