Switch On Machine; Switch Off Machine; Manual In Feed Of Grinding Material - Virtus H 80 Series Operating Manual

PART A: Basic machine
Granulator
H 80 Series
7.2

Switch on machine

1. Switch on the grinding material discharge device.
2. Switch on the granulator (main switch to 1). Wait until the rotor has
3. Switch on the grinding material in feed device (accessories).
7.3

Switch off machine

1. Switch off the grinding material in feed device (accessories).
2. Wait until the remaining grinding material has been ground, then
3. Switch off the grinding material discharge device.
7.4

Manual in feed of grinding material

DANGER
 Throw the grinding material into the grinding chamber through the
 VIRTUS 2023, All rights reserved
reached its full speed and switched from star to delta.
switch off the granulator, (main switch to 0).
Rotating knives.
Can cause serious cutting and crushing injuries, possibly
leading to death.
Do not reach into the in feed hopper or lean in whilst the
rotor is running (pay attention to the 3 minute run down
time). Only use approved grinding material.
splash guard.
If in your design of machine an additional in feed device is
installed, please observe the additional information for work with
and on the in feed device Part B: Accessories.
Page 48