Table of Contents
Advertisement
PART A: Basic machine
Granulator
H 80 Series
5
DESCRIPTION OF THE MACHINE
5.1
Grinding material in feed
5.1.1
In feed hopper
5.1.2
Additional in feed device
VIRTUS 2023, All rights reserved
The grinding material can be fed into the granulator in the
following ways:
•
Manual in feed of the grinding material directly into the in feed
hopper.
•
Manual in feed of the grinding material with the help of an
additional in feed device (e.g. nip roll feed device).
•
Automatic in feed of the grinding material by means of an
additional in feed device (e.g. conveyor belt).
The grinding material in feed ensues via an in feed hopper, which
is formed so that the grinding material can be delivered correctly
and safely. A splashguard at the input opening prevents thrown-
back parts being able to escape. The grinding material in feed can
take place manually or with the help of an additional in feed
device.
DANGER
Material fly back can occur out of the hopper opening.
Serious injury or death can result.
Do not remove the splash guards from hopper or throw in
material larger than the hoppers capacity
Splash guards has to be closed during grinding
WARNING
If using a hopper with side infeed or pipe hopper:
The material shall be shorter than 80% of the side arms
length!
If your machine has an optional in feed device such as roller
feeder or conveyor belt please refer to the additional information
about the accessories in the appendix.
Page 32
Advertisement
Table of Contents
